How To Take A Bicycle Chain Off

Easy Steps to Remove Bicycle Chain

Taking a bicycle chain off may seem like a daunting task, but with a few simple steps, it can be easily accomplished. First, you will need to ensure that you have the necessary tools for the job, primarily a chain tool. This specialized tool is designed specifically for removing bike chains and can be easily found at most bike shops. Once you have the chain tool, position your bike in a way that allows easy access to the chain, such as placing it on a bike stand or turning it upside down.

Easy Steps for Removing Bike Chain

To start the chain removal process, shift your bike into the smallest chainring and smallest rear cog. This will help relieve tension on the chain and allow for easier removal. Using the chain tool, locate the joining pin on the chain. Insert the chain tool’s pin into one of the chain’s outer links, making sure it lines up with the joining pin. Slowly tighten the chain tool by rotating the handle clockwise until the joining pin starts to loosen and pushes out towards the opposite side of the link.

Easy Steps to Remove Bike Chain

To completely remove the chain, continue tightening the chain tool until the joining pin is no longer holding the link together. Slide the loosened link off the chain tool’s pin, and the chain will then separate into two halves. Be cautious not to misplace the joining pin, as it will be needed for reinstalling the chain. At this point, the chain is fully detached, and you can proceed with any necessary maintenance or repairs, such as cleaning or replacing the chain.

Important steps for reinstalling bike chain

When reinstalling the chain, it is crucial to ensure proper alignment and tension. Begin by threading the chain through the bike’s derailleur, ensuring it is properly seated on the smallest chainring and smallest rear cog. Connect the two halves of the chain by aligning their outer links and reinsert the joining pin, making sure it is correctly aligned with the roller of the adjacent link. Use the chain tool to slowly push the joining pin back into place, stopping once it is flush with the outer edge of the link.

About me

Blogger at Bicycle & Bike | Website | + posts

I got my first bicycle when I was 3 years old. 10x years later I still love to cycle! In the meantime, I also developed an absolute obsession with motorbikes! I write about my hobbies and lifestyle on this blog.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *